Users Guide

debug lldp interface
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other information about incoming and outgoing
packets.
Syntax
debug lldp interface {interface | all}{events | packet {brief | detail} {tx |
rx | both}}
To disable debugging, use the no debug lldp interface {interface | all}{events} {packet
{brief | detail} {tx | rx | both}} command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet
followed by the slot/port information.
all (OPTIONAL) Enter the keyword all to display information on all interfaces.
events (OPTIONAL) Enter the keyword events to display major events such as timer events.
packet (OPTIONAL) Enter the keyword packet to display information regarding packets
coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet information.
detail (OPTIONAL) Enter the keyword detail to display detailed packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit-only packet information.
rx (OPTIONAL) Enter the keyword rx to display receive-only packet information.
both (OPTIONAL) Enter the keyword both to display both receive and transmit packet
information.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
disable
Enable or disable LLDP.
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
280 Link Layer Discovery Protocol (LLDP)