Users Guide

NOTE: LACP modes are defined in Usage Information .
passive Enter the keyword passive to set the mode to the passive state.
NOTE: LACP modes are defined in Usage Information .
off Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information .
Defaults off
Command Modes INTERFACE
Supported Modes
Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information LACP Modes
Mode Function
active An interface is in an active negotiating state in this mode. LACP runs on any link
configured in the active state and also automatically initiates negotiation with other ports
by initiating LACP packets.
passive An interface is not in an active negotiating state in this mode. LACP runs on any link
configured in the passive state. Ports in a passive state respond to negotiation requests
from other ports that are in active states. Ports in a passive state respond to LACP
packets
off An interface cannot be part of a dynamic port channel in off mode. LACP does not run on
a port configured in off mode.
port-channel-protocol lacp
Enable LACP on any LAN port.
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp command.
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
262 Link Aggregation Control Protocol (LACP)