Users Guide

Field Description
• + = summary routes
Destination Identifies the route’s destination IP address.
Gateway Identifies whether the route is directly connected and on which interface the route is
configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Example (Summary)
Dell#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
Dell#show ip route static ?
| Pipe through a command
<cr>
Dell#show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Te 1/2 1/0 3d2h
Dell#
show tcp statistics
View information on TCP traffic through the switch.
Syntax
show tcp statistics
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The following describes the show tcp statistics cp command shown in the following example.
Field Description
Rcvd: Displays the number and types of TCP packets received by the switch.
• Total = total packets received
• no port = number of packets received with no designated port
0 checksum error... Displays the number of packets received with the following:
• checksum errors
• bad offset to data
IPv4 Routing 245