Users Guide

Example-Multiple
Range Bulk
Configuration with
VLAN and port
channel
The following example shows how to use commas to add VLAN and port-channel interfaces to the range.
Dell(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet
1/1 – 2,
Vlan 2 – 100 , Port 1 – 25
Dell(conf-if-range)# no shutdown
Dell(conf-if-range)#
Related commands show config (from INTERFACE RANGE mode)— Shows the bulk configuration interfaces.
show interfaces status— Displays a summary of interface information.
interface vlan
Configure a VLAN. Configure the default VLAN to enable Static or DCHP IP configuration. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter 1 for the default VLAN. Enter a number as the VLAN identifier. The range is from 1
to 4096.
Defaults Not configured, except for the default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information For more information about VLANs and the commands to configure them, refer to Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are not supported.
Examples
Dell(conf)#int vlan 1
Dell(conf-if-vl-1)#
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related commands show vlan — Displays the current VLAN configuration on the switch.
vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.
202 Interfaces