Users Guide

on on on on
off off off off
off off off off
on on on on
on on on on
Related Commands
show running-config — displays the flow configuration parameters (non-default values only).
show interfaces — displays the negotiated flow control parameters.
interface
Configure a physical interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode,
ensure that the interface’s configuration does not contain an IP address and enter the Port Channel
Commands
command. By default, in PMUX mode, the interface is shut down when the portmode hybrid and
switchport are enabled.
The tunnel interface operates as an ECMP (equal cost multipath) only when the next hop to the tunnel destination
is over a physical interface. If you select any other interface as the next hop to the tunnel destination, the tunnel
interface does not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/1
Dell(conf-if-te-0/1)#exit#
Related Commands
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
198 Interfaces