Users Guide

An FCoE map consists of the following parameters: the dedicated FCoE VLAN for storage traffic, the destination
SAN fabric (FC-MAP value), FCF priority, and the FIP keepalive (FKA) advertisement timeout.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in Interface
configuration mode.
NOTE: You cannot create fcoe-map in IOA mode. It can only be created in PMUX mode.
NOTE: In FCF F mode, you can create only one FCoE map. It doesn’t get created automatically. If you
try to create more than one map, an error message is displayed.
Related Commands
show fcoe-map — displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
feature fc
Enable feature fc with FPort functionality.
Syntax
feature fc fport domain-id range
Parameters
Range Enter the range from 1 to 239.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Supported on the FN I/O Aggregator.
9.7(0.0) Introduced on the M I/O Aggregator.
Usage Information Enable remote-fault-signaling rx off command in FCF FPort mode on interfaces connected to the
Compellent and MDF storage devices.
Example
Dell(conf)#feature fc fport domain-id
show fc alias
Display the configured alias.
Syntax
show fc alias [ZoneAliasName ]
Parameters
ZoneAliasName Enter the zone alias name to display the details.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Supported on the FN I/O Aggregator.
FC FLEXIO FPORT 159