Users Guide

Parameters
brief Displays an overview of currently configured FCoE maps.
map-name Displays the FC and FCoE configuration parameters in a specified FCoE map. The FCoE
map is applied on Ethernet (FCoE) and FC ports to transmit FC storage traffic to a
specified fabric.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
Usage Information
Use the show fcoe-map command to display the FC and FCoE parameters used to configure server-facing
Ethernet (FCoE) and fabric-facing FC ports in all FCoE maps on an M I/O Aggregator with the FC Flex IO module
NPIV proxy gateway.
In each FCoE map, the values for the fabric ID and FC-MAP that identify the SAN fabric to which FC storage
traffic is sent, and the FCoE VLAN to be used must be unique.
An FCoE map is used to identify the SAN fabric to which FCoE storage traffic is sent and to virtualize M I/O
Aggregator with the FC Flex IO module FC ports so that they appear to downstream server CNA ports as FCoE
Forwarder (FCF) ports on an FCoE network.
The following table describes the show fcoe-map brief output shown in the example below.
Field Description
Fabric-Name Name of a SAN fabric.
Fabric ID The ID number of the SAN fabric to which FC traffic is forwarded.
VLAN ID The dedicated FCoE VLAN used to transport FCoE storage traffic between servers and a
fabric over the NPIV proxy gateway. The configured VLAN ID must be the same as the
fabric ID.
FC-MAP FCoE MAC address-prefix value - The unique 24-bit MAC address prefix that identifies a
fabric.
FCF Priority The priority used by a server to select an upstream FCoE forwarder.
Config-State Indicates whether the configured FCoE and FC parameters in the FCoE map are valid:
Active (all mandatory FCoE and FC parameters are correctly configured) or Incomplete
(either the FC-MAP value, fabric ID, or VLAN ID are not correctly configured).
Oper-State Operational status of link to the fabric: Up (link is up and transmitting FC traffic), Down
(link is down and not transmitting FC traffic), Link-wait (link is up and waiting for FLOGI
to complete on peer FC port), or Removed (port has been shut down).
The following table describes the show fcoe-map map-name output shown in the example below.
FC Flex IO Modules 149