Users Guide

In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must be unique. Use one FCoE map
to access one SAN fabric. You cannot use the same FCoE map to access different fabrics.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in Interface
configuration mode.
Related Commands
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
fka-adv-period
In an FCoE map, configure the time interval used to transmit FIP keepalive (FKA) advertisements.
M I/O Aggregator with the FC Flex IO module
Syntax
fka-adv-period seconds
Parameters
seconds Enter the time period (in seconds) used to send FIP keepalive messages to peer devices.
The range is from 8 to 90 seconds.
Defaults 8 seconds
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
Usage Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-adv-erpiod command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
interface vlan (NPIV proxy gateway)
Create a dedicated VLAN to be used to send and receive Fibre Channel traffic over FCoE links between servers and a fabric over an M I/O
Aggregator with the PMUX module NPIV proxy gateway.
M I/O Aggregator with the FC Flex IO module
Syntax
interface vlan vlan-id
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is 1 to 4094.
146 FC Flex IO Modules