Users Guide

Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
NOTE: This command also enables you to view information corresponding to a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface configurations
corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Summary)
Dell#show interfaces te 0/3 pfc statistics
Interface TenGigabitEthernet 0/3
Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
--------------------------------------------------------
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 0 0
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the specified map.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
130 Data Center Bridging (DCB)