Users Guide

Typical order of methods: RADIUS, TACACS+, Local, None.
If RADIUS denies authorization, the session ends (RADIUS must not be the last method specied).
Applying the Method List to Terminal Lines
To enable RADIUS AAA login authentication for a method list, apply it to a terminal line.
To congure a terminal line for RADIUS authentication and authorization, use the following commands.
• Enter LINE mode.
CONFIGURATION mode
line {aux 0 | console 0 | vty number [end-number]}
• Enable AAA login authentication for the specied RADIUS method list.
LINE mode
login authentication {method-list-name | default}
This procedure is mandatory if you are not using default lists.
• To use the method list.
CONFIGURATION mode
authorization exec methodlist
Specifying a RADIUS Server Host
When conguring a RADIUS server host, you can set dierent communication parameters, such as the UDP port, the key password, the
number of retries, and the timeout.
To specify a RADIUS server host and congure its communication parameters, use the following command.
• Enter the host name or IP address of the RADIUS server host.
CONFIGURATION mode
radius-server host {hostname | ip-address} [auth-port port-number] [retransmit retries]
[timeout seconds] [key [encryption-type] key]
Congure the optional communication parameters for the specic host:
• auth-port port-number: the range is from 0 to 65535. Enter a UDP port number. The default is 1812.
• retransmit retries: the range is from 0 to 100. Default is 3.
• timeout seconds: the range is from 0 to 1000. Default is 5 seconds.
• key [encryption-type] key: enter 0 for plain text or 7 for encrypted text, and a string for the key. The key can be up to 42
characters long. This key must match the key congured on the RADIUS server host.
If you do not congure these optional parameters, the global default values for all RADIUS host are applied.
To specify multiple RADIUS server hosts, congure the radius-server host command multiple times. If you congure multiple
RADIUS server hosts, Dell Networking OS attempts to connect with them in the order in which they were congured. When Dell
Networking OS attempts to authenticate a user, the software connects with the RADIUS server hosts one at a time, until a RADIUS server
host responds with an accept or reject response.
If you want to change an optional parameter setting for a specic host, use the radius-server host command. To change the global
communication settings to all RADIUS server hosts, refer to Setting Global Communication Parameters for all RADIUS Server Hosts.
To view the RADIUS conguration, use the show running-config radius command in EXEC Privilege mode.
To delete a RADIUS server host, use the no radius-server host {hostname | ip-address} command.
194
Security