Reference Guide

Related
Commands
telnet — telnets to another device.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to configure the console port.
The console option is <0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to
configure a virtual terminal line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number
(OPTIONAL) Enter a number from 1 to 9 as the last virtual
terminal line to configure.
You can configure multiple lines at one time.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
You cannot delete a terminal connection.
Related
Commands
show memory— View current memory usage on the M I/O Aggregator.
ping
Test connectivity between the system and another device by sending echo requests and waiting for
replies.
Syntax
ping [host | ip-address] [count {number | continuous}]
[datagram-size] [timeout] [source (ip src-ipv4-address) |
interface] [tos] [df-bit (y|n)] [validate-reply(y|n)] [pattern
pattern] [sweep-min-size] [sweep-max-size] [sweep-interval]
[ointerface (ip src-ipv4-address) | interface]
Control and Monitoring
59