Reference Guide

Version
8.3.12.0
Added support for the peer-down-vlan parameter.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
To configure the VLAN from where the VLT peer forwards packets received over
the VLTi from an adjacent VLT peer that is down, use the peer-down-vlan
parameter. When a VLT peer with bare metal provisioning (BMP) is booting up, it
sends untagged DHCP discover packets to its peer over the VLTi. To ensure that
the DHCP discover packets are forwarded to the VLAN that has the DHCP server,
use this configuration.
show vlt mismatch
Display mismatches in VLT parameters.
Syntax
show vlt mismatch
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Example
Dell#show vlt mismatch
Domain
-----------
Parameters Local Peer
------------ ----------- ---------
Unit-ID 0 15
Vlan-config
------------
Vlan-ID Local Mode Peer Mode
--------- ------------ -----------
100 -- L3
Vlan IPV4 Multicast Status
--------------------------
Vlan-ID Local Status Peer Status
-------- ------------ -----------
4094 Active Inactive
Dell#
PMUX Mode of the I/O Aggregator
495