Reference Guide

• If you are using access control lists (ACLs) in an SNMP v3 configuration, group ACL overrides user ACL
if the user is part of that group.
• SNMP operations are not supported on a virtual local area network (VLAN).
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type
] [notification-option] command.
Parameters
notification-
type
Enter the type of notification from the following list:
• bgp — Notification of changes in the BGP process.
• config — Notification of changes to the startup or
running configuration.
• ecfm — Notification of changes to ECFM.
• ecmp — Enable an ECMP trap to notify of ECMP or link
bundle traffic imbalances.
• envmon — For Dell Networking device notifications when
an environmental threshold is exceeded.
• isis — Notification of intermediate service traps.
• lacp — Notification of changes.
• snmp — Notification of RFC 1157 traps.
• stp — Notification of a state change in the spanning tree
protocol (RFC 1493).
• vlt — Notification of virtual link trunking.
• vrrp — Notification of a state change in a VRRP group.
• xstp — Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
notification-
option
For the envmon notification-type, enter one of the following
optional parameters:
• cam-utilization
• fan
• supply
• temperature
For the snmp notification-type, enter one of the following
optional parameters:
• authentication
• coldstart
• linkdown
• linkup
PMUX Mode of the I/O Aggregator
465