Reference Guide

Usage
Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic.
Aggregate input/output QoS policy can coexist with per queue input/output QoS
policies.
1. If only aggregate input QoS policy exists, input traffic conditioning
configurations (rate-police) apply. Any marking configurations in aggregate
input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist,
aggregate input QoS policy preempts per class input QoS policy on input
traffic conditioning (rate-police). In other words, if rate police configuration
exists in the aggregate QoS policy, the rate police configurations in per class
QoS are ignored. Marking configurations in per class input QoS policy still
apply to each queue.
Related
Commands
policy-map-output — creates an output policy map.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-
name
Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
458
PMUX Mode of the I/O Aggregator