Reference Guide

4 0-7
5 0-7
6 0-7
7 0-7
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Related
Commands
service-class dot1p-mapping — displays the dot1p priority to queue mapping on
the switch.
service-class bandwidth-percentage
Specify a minimum bandwidth for queues.
Syntax
service-class bandwidth-percentage queue0 number queue1 number
queue2 number queue3 number
Parameters
number Enter the bandwidth-weight, as a percentage. The range is
from 1 to 100.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
PMUX Mode of the I/O Aggregator
455