Reference Guide

dot1p Queue ID
5 3
6 3
7 3
Command
Modes
• INTERFACE
• CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To honor all incoming 802.1p markings on incoming switched traffic on the
interface, enter this command. By default, this facility is not enabled (that is, the
802.1p markings on incoming traffic are not honored).
You can apply this command on both physical interfaces and port channels. When
you set the service-class dynamic for a port channel, the physical interfaces
assigned to the port channel are automatically configured; you cannot assign the
service-class dynamic command to individual interfaces in a port channel.
• All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p
command on an interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 queue | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
Parameters
value Enter a dot1p list number and value. The list number range is
from 0 to 7. The range is from 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p CoS Queue
0 0-7
1 0-7
2 0-7
3 0-7
454
PMUX Mode of the I/O Aggregator