Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
This last-member-query-interval is also the interval between successive Group-
Specific Query messages. To change the last-member-query interval, use this
command.
ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping
mrouter interface
interface command.
Parameters
interface
interface
Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
then a number. For the C-Series and S-Series,
the range is from 1 to 128.
Defaults Not configured.
Command
Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
PMUX Mode of the I/O Aggregator
441