Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator

431

432

433

434

435

436

437

438

439

440

Version 9.0.2.0 Introduced on the S6000.

Version

8.3.19.0

Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.

E-Series legacy

command.

Usage

Information

Queriers normally send some queries when a leave message is received prior to

deleting a group from the membership database. There may be situations when

you require a fast deletion of a group. When you enable IGMP fast leave

processing, the switch removes an interface from the multicast group as soon as it

detects an IGMP version 2 leave message on the interface.

ip igmp snooping last-member-query-interval

The last member query interval is the maximum response time inserted into Group-Specific queries sent

in response to Group-Leave messages.

Syntax

ip igmp snooping last-member-query-interval milliseconds

To return to the default value, use the no ip igmp snooping last-member-

query-interval

command.

Parameters

milliseconds Enter the interval in milliseconds. The range is from 100 to

65535. The default is 1000 milliseconds.

Defaults 1000 milliseconds

Command

Modes

INTERFACE VLAN

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.