Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To enable IGMP snooping, enter this command. When you enable this command
from CONFIGURATION mode, IGMP snooping enables on all VLAN interfaces
(except the default VLAN).
NOTE: Execute the no shutdown command on the VLAN interface for IGMP
Snooping to function.
Related
Commands
shutdown — (no shutdown) activates an interface.
ip igmp snooping fast-leave
Enable IGMP snooping fast-leave for this VLAN.
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave
command.
Defaults Not configured.
Command
Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
PMUX Mode of the I/O Aggregator
439