Reference Guide

Parameters
seconds Enter the number of seconds for the maximum response
time. The range is from 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to
IGMPv2.
3 Enter the number 3 to set the IGMP version number to
IGMPv3.
Defaults 2 (that is, IGMPv2)
Command
Modes
INTERFACE
PMUX Mode of the I/O Aggregator
437