Reference Guide

Related
Commands
dcb-policy output stack-unit stack-ports all — applies the specified DCB output
policy.
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is
32 characters.
Defaults none
Command
Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Related
Commands
• dcb-input — creates a DCB PFC input policy.
• dcb-policy input — applies the output policy.
• dcb-output — creates a DCBETS output policy.
• dcb-policy output — applies the output policy.
pfc link-delay
Configure the link delay used to pause specified priority traffic.
Syntax
pfc link-delay value
To remove the link delay, use the no pfc link-delay command.
Parameters
value The range is (in quanta) from 712 to 65535. One quantum is
equal to a 512-bit transmission.
Defaults 45556 quantum
Command
Modes
DCB INPUT POLICY
Command
History
Version 9.3.0.0 Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
FC Flex IO Modules
347