Reference Guide

DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
Peer DCBX Status:
----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
ETS Commands
The following ETS commands are supported on the FC Flex IO module installed in the M I/O Aggregator.
bandwidth-percentage
Configure the bandwidth percentage allocated to priority traffic in port queues.
Syntax
bandwidth-percentage percentage
To remove the configured bandwidth percentage, use the no bandwidth-
percentage command.
Parameters
percentage (Optional) Enter the bandwidth percentage. The percentage
range is from 1 to 100% in units of 1%.
Defaults none
Command
Modes
QOS-POLICY-OUT-ETS
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch.
Usage
Information
By default, equal bandwidth is assigned to each port queue and each dot1p priority
in a priority group. To configure bandwidth amounts in associated dot1p queues,
use the bandwidth-percentage command. When specified bandwidth is
assigned to some port queues and not to others, the remaining bandwidth (100%
minus assigned bandwidth amount) is equally distributed to unassigned nonstrict
priority queues in the priority group. The sum of the allocated bandwidth to all
queues in a priority group must be 100% of the bandwidth on the link.
ETS-assigned bandwidth allocation applies only to data queues, not to control
queues.
The configuration of bandwidth allocation and strict-queue scheduling is not
supported at the same time for a priority group. If you configure both, the
FC Flex IO Modules
327