Reference Guide

Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
• ets-conf: enables the advertisement of ETS
configuration TLVs.
• ets-reco: enables the advertisement of ETS
recommend TLVs.
• pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command
Modes
PROTOCOL LLDP
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Usage
Information
You can configure the transmission of more than one TLV type at a time; for
example: advertise dcbx-tlv ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS
configuration TLVs (ets-conf). To disable TLV transmission, use the no form of
the command; for example, no advertise dcbx-tlv pfc ets-reco.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.
dcbx port-role
Configure the DCBX port role the interface uses to exchange DCB information.
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream
| manual}
To remove DCBX port role, use the no dcbx port-role {config-source |
auto-downstream | auto-upstream | manual}
command.
Parameters
config-source |
auto-
downstream |
auto-upstream
| manual
Enter the DCBX port role, where:
• config-source: configures the port to serve as the
configuration source on the switch.
• auto-upstream: configures the port to receive a peer
configuration. The configuration source is elected from
auto-upstream ports.
• auto-downstream: configures the port to accept the
internally propagated DCB configuration from a
configuration source.
FC Flex IO Modules
321