Reference Guide

Command
Modes
CONFIGURATION
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator.
Usage
Information
DCB is not supported if you enable link-level flow control on one or more
interfaces.
DCBX Commands
The following DCBX commands are supported on the FC Flex IO module installed in the M I/O
Aggregator.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to
DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-
tlv {fcoe | iscsi} command.
Parameters
{fcoe | iscsi} Enter the application priority TLVs, where:
• fcoe: enables the advertisement of FCoE in application
priority TLVs.
• iscsi: enables the advertisement of iSCSI in application
priority TLVs.
Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command
Modes
PROTOCOL LLDP
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Usage
Information
To disable TLV transmission, use the no form of the command; for example, no
advertise dcbx-appln-tlv iscsi
.
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-
reco | pfc] [ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
320
FC Flex IO Modules