Reference Guide

stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority 1-14
Parameters
stack-number Enter the stack member unit identifier.
1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch with
the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
Defaults 0
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Introduced on the M I/O Aggregator.
Related
Commands
• reload – reboots Dell Networking Operating System (OS).
• show system – displays the status of all stack members or a specific member.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax
stack-unit 0-5 renumber 0-5
Parameters
0-5 The first instance of this value is the stack member unit
identifier, from 0 to 5, of the switch that you want add to the
stack. The range is from 0 to 5. The second instance of this
value is the desired new unit identifier number.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.3(0.0) Introduced on the M I/O Aggregator
Usage
Information
You can renumber any switch, including the management unit or a stand-alone
unit.
You cannot renumber a unit to a number of an active member in the stack.
Stacking Commands
273