Reference Guide

Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is
from 0 to 5.
Command
Modes
EXEC Privilege
Command
History
Version 9.3.0.0 Introduced on the M I/O Aggregator
Usage
Information
The value under the Boot-speed field in the output of the show command
indicates the uplink speed that is currently effective on the LAG bundles, whereas
the value under the Next-Boot field indicates the uplink speed that is applicable for
the LAG bundle after the next reboot of the switch.
Example
Dell# show system stack-unit 0 iom-uplink-speed
Unit Boot-speed Next-Boot
------------------------------------------------
0 10G 40G
show system stack-unit stack-group
Displays the stack-groups present/configured for a M I/O Aggregator stack unit.
Syntax
show system stack-unit unit-number stack-group [configured]
Parameters
unit number
<0–5>
Enter the number of the member stack unit. The range is
from 0 to 5.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show system stack-unit 0 stack-group ?
configured Configured stack groups
| Pipe through a command
<cr>
Dell#show system stack-unit 0 stack-group configured
Configured stack groups in stack-unit 0
Dell#show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/33
1 0/37
2 0/41
3 0/45
Dell#
270
Stacking Commands