Reference Guide

logging hostname
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
Syntax
logging {ipv4-address | hostname}
To disable logging, use the no logging command.
Parameters
ipv4-address Enter the IPv4 address (A.B.C.D).
hostname Enter the name of a host already configured and recognized
by the switch.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Related
Commands
logging trap— enables logging to the Syslog server based on severity.
logging monitor
Specify which messages are logged to Telnet applications.
Syntax
logging monitor [level]
To disable logging to terminal connections, use the no logging monitor
command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following
parameters: emergencies, alerts, critical, errors,
warnings, notifications, informational, or
debugging. The default is 7 or debugging.
Defaults 7 or debugging
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Related
Commands
logging hostname— returns the logging monitor parameters to the default setting.
260
Simple Network Management Protocol (SNMP) and Syslog