Reference Guide

Related
Commands
negotiation auto — enables or disables auto-negotiation on an interface.
tdr-cable-test
Test the condition of copper cables on 100/1000/10GBase-T modules.
Syntax
tdr-cable-test interface
Parameters
interface Enter the keyword TenGigabitEthernet followed by the
slot/port information for the 100/1000/10GBase-T Ethernet
interface.
Defaults none
Command
Modes
EXEC
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The interface must be enabled to run the test or an error message is generated:
Dell#tdr-cable-test tengigabitethernet 5/2
%Error: Interface is disabled TenGIG 5/2
Related
Commands
show tdr— Displays the results of the TDR test.
vlan tagged (CMC)
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax
tagged interface
To remove a tagged interface from a VLAN, use the no tagged interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
Interfaces
183