Reference Guide

Parameters
interface Enter the one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
destination Enter the keyword destination to indicate the interface
destination.
direction {rx | tx
| both}
Enter the keyword direction then one of the packet
directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving
packets.
Defaults none
Command
Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Version 9.3(0.0) Added support for the fortyGigE keyword on M I/O
Aggregator
Version 8.3.17.0 Supported on M I/O Aggregator
Example
Dell(conf-mon-sess-11)#source fortygi 10/0 destination gi
10/47 direction rx
Dell(conf-mon-sess-11)#
show config (INTERFACE mode)
Displays the interface configuration.
Syntax
show config
Command
Modes
INTERFACE
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
164
Interfaces