Reference Guide

system.
Dell(conf)#end
Dell#00:02:38: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from
console
Dell#write memory
00:02:41: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-
config to
startup-config in flash by default
Dell#reload
Proceed with reload [confirm yes/no]: yes
syncing disks... done
unmounting file systems...
unmounting /f10/flash (/dev/ld0e)...
unmounting /usr (mfs:31)...
unmounting /lib (mfs:23)...
unmounting /f10 (mfs:20)...
unmounting /tmp (mfs:15)...
unmounting /kern (kernfs)...
unmounting / (/dev/md0a)... done
rebooting...
Dell#show dcb stack-unit 0 port-set 0
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
Dell#
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
I/O Aggregator
Syntax
dcb-map map-name
Parameters
map-name Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet
interfaces.
Command
Modes
CONFIGURATION
INTERFACE
Command
History
Version 9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O
Aggregator.
Usage
Information
A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
Data Center Bridging (DCB)
107