Users Guide

stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax
stack-unit 0-5 renumber 0-5
Parameters
0-5 The rst instance of this value is the stack member unit identier, from 0 to 5, of the
switch that you want add to the stack. The range is from 0 to 5. The second instance of
this value is the desired new unit identier number.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information
This command is supported on the FN410S and the FN410T Aggregators.
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered, only that
specic unit is reset and comes up with the new unit number.
Example
Dell#stack-unit 5 renumber 4
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related Commands
• reload – reboots Dell Networking Operating System (OS).
• reset stack-unit – resets the designated stack member.
• show system – displays the current status of all stack members or a specic member.
Stacking Commands 371