Users Guide

2 Congure a remote user.
3 Congure a group for this user with access rights.
4 Enable traps.
5 Congure a host to receive informs.
Related Commands
snmp-server enables— enables SNMP traps.
snmp-server user
Congure a new user to an SNMP group.
Syntax
snmp-server user name {group_name [access access-list-name | ipv6 access-list-
name | access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name [access
access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-
name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that connects to
the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The following
groups are created for mapping to read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
access access-list-
name
(Optional) Enter the standard IPv4 access list name (a string up to 16 characters long).
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then the IPv6 access list name (a string up to 16
characters long).
access-list-name
ipv6 access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0)
Introduced on the M I/O Aggregator.
360 Simple Network Management Protocol (SNMP) and Syslog