Users Guide
To remove the congured iSCSI priority, use the no iscsi priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Command Modes PROTOCOL LLDP
Supported Modes
Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is available at the global level only.
iscsi prole-compellent
Congure the auto-detection of Dell Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command Modes INTERFACE
Supported Modes
Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
iscsi target port
Congure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address]
To remove the congured iSCSI target ports or IP addresses, use the no iscsi target port command.
iSCSI Optimization 251