Users Guide

exchng | fail | mgmt
| resource | sem |
tlv}
• auto-detect-timer: enables traces for DCBX auto-detect timers.
• config-exchng: enables traces for DCBX conguration exchanges.
• fail: enables traces for DCBX failures.
• mgmt: enables traces for DCBX management frames.
• resource: enables traces for DCBX system resource frames.
• sem: enables traces for the DCBX state machine.
• tlv: enables traces for DCBX TLVs.
Defaults none
Command Modes EXEC Privilege
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
fc-map
In an FCoE map, congure the FCoE mapped address prex (FC-MAP) value which is used to identify FCoE trac transmitted on the
FCoE VLAN for the specied fabric.
Syntax
fc—map fc-map-value
Parameters
fc-map-value Enter the unique MAC address prex used by a SAN fabric.
The range of FC-MAP values is from 0EFC00 to 0EFCFF.
Defaults None
Command Modes FCoE MAP
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
Usage Information
The FC-MAP value you enter must match the FC-MAP value used by an FC switch or FCoE forwarder (FCF) in
the fabric. An FCF switch accepts only FCoE trac that uses the correct FC-MAP value.
The FC-MAP value is used to generate the fabric-provided MAC address (FP-MAC). The FPMA is used by servers
to transmit FCoE trac to the fabric. An FC-MAP can be associated with only one FCoE VLAN and vice versa.
In an FCoE map, the FC-MAP value, fabric ID, and FCoE VLAN parameters must be unique.
110 Data Center Bridging (DCB)