Users Guide

shared-
threshold-
weight on the
queue
Description heading
5 11.11%
6 20%
7 33.33%
8 50%
9 66.67%
10 80%
11 88.89%
Example
Dell(conf-if-te-1/8)#Service-class buffer shared-threshold-weight queue5 4
queue7 6
dcbx-port role
Congure the DCBX port role the interface uses to exchange DCB information.
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream | manual}
To remove DCBX port role, use the no dcbx port-role {config-source | auto-downstream |
auto-upstream | manual} command.
Parameters
cong-source |
auto-downstream |
auto-upstream |
manual
Enter the DCBX port role, where:
• config-source: congures the port to serve as the conguration source on the
switch.
• auto-upstream: congures the port to receive a peer conguration. The
conguration source is elected from auto-upstream ports.
•
auto-downstream: congures the port to accept the internally propagated DCB
conguration from a conguration source.
• manual: congures the port to operate only on administer-congured DCB
parameters. The port does not accept a DCB conguration received form a peer or a
local conguration source.
Defaults Manual
Command Modes INTERFACE PROTOCOL LLDP
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
108 Data Center Bridging (DCB)