Reference Guide

show Show LLDP configuration
R1(conf-if-gi-1/31-lldp)#
Enabling LLDP
LLDP is enabled by default. Enable and disable LLDP globally or per interface. If you enable LLDP globally,
all UP interfaces send periodic LLDPDUs.
To enable LLDP, use the following command.
1. Enter Protocol LLDP mode.
CONFIGURATION or INTERFACE mode
protocol lldp
2. Enable LLDP.
PROTOCOL LLDP mode
no disable
Disabling and Undoing LLDP
To disable or undo LLDP, use the following command.
• Disable LLDP globally or for an interface.
disable
To undo an LLDP configuration, precede the relevant command with the keyword no.
Advertising TLVs
You can configure the system to advertise TLVs out of all interfaces or out of specific interfaces.
• If you configure the system globally, all interfaces send LLDPDUs with the specified TLVs.
• If you configure an interface, only the interface sends LLDPDUs with the specified TLVs.
• If you configure LLDP both globally and at interface level, the interface level configuration overrides
the global configuration.
PMUX Mode of the IO Aggregator
215