Users Guide
Admin is enabled
TC-grp Priority# Bandwidth TSA
0 0,1,2,3,4,5,6,7 100% ETS
1 0% ETS
2 0% ETS
3 0% ETS
4 0% ETS
5 0% ETS
6 0% ETS
7 0% ETS
Remote Parameters:
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
PG-grp Priority# Bandwidth TSA
0 0,1,2,3,4,5,6,7 100% ETS
1 0% ETS
2 0% ETS
3 0% ETS
4 0% ETS
5 0% ETS
6 0% ETS
7 0% ETS
Oper status is init
ETS DCBX Oper status is Down
State Machine Type is Asymmetric
Conf TLV Tx Status is enabled
Reco TLV Tx Status is enabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Reco TLV Pkts, 0 Output Reco TLV Pkts, 0 Error Reco TLV Pkts
The following table describes the show interface ets detail command elds.
Field
Description
Interface Interface type with stack-unit and port number.
Max Supported TC
Group
Maximum number of priority groups supported.
Number of Trac
Classes
Number of 802.1p priorities currently congured.
Admin mode ETS mode: on or o.
When on, the scheduling and bandwidth allocation congured in an ETS output policy or received in a DCBx TLV
from a peer can take eect on an interface.
Admin Parameters ETS conguration on local port, including priority groups, assigned dot1p priorities, and bandwidth allocation.
Remote Parameters ETS conguration on remote peer port, including Admin mode (enabled if a valid TLV was received or disabled),
priority groups, assigned dot1p priorities, and bandwidth allocation. If the ETS Admin mode is enabled on the
remote port for DCBx exchange, the Willing bit received in ETS TLVs from the remote peer is included.
Local Parameters ETS conguration on local port, including Admin mode (enabled when a valid TLV is received from a peer), priority
groups, assigned dot1p priorities, and bandwidth allocation.
Operational status
(local port)
Port state for current operational ETS conguration:
• Init: Local ETS conguration parameters were exchanged with peer.
• Recommend: Remote ETS conguration parameters were received from peer.
58 Data Center Bridging (DCB)