Users Guide

G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT
untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Active U Po10(Te 0/4-5)
U Po11(Te 0/6)
1000 Active T Po10(Te 0/4-5)
1001 Active T Po11(Te 0/6)
Dell#
5 Show LAG member ports utilization.
Dell#show link-bundle-distribution
Link-bundle trigger threshold - 60
LAG bundle - 10 Utilization[In Percent] - 0 Alarm State - Inactive
Interface Line Protocol Utilization[In Percent]
Te 0/41 Up 0
Te 0/42 Up 0
LAG bundle - 11 Utilization[In Percent] - 0 Alarm State - Inactive
Interface Line Protocol Utilization[In Percent]
Te 0/6 Up 0
Dell#
Multiple Uplink LAGs with 40G Member Ports
By default in IOA, native 40G QSFP+ optional module ports are used in Quad (4x10G) mode, to convert Quad mode to Native 40G mode,
refer to the sample conguration. Also note, converting between Quad mode and Native mode, and vice versa, requires that you reload the
system for the conguration changes to take eect.
The following sample commands congure multiple dynamic uplink LAGs with 40G member ports based on LACP.
1 Convert the quad mode (4x10G) ports to native 40G mode.
Dell#configure
Dell(conf)#no stack-unit 0 port 33 portmode quad
Disabling quad mode on stack-unit 0 port 33 will make interface configs of Te 0/33 Te 0/34
Te 0/35 Te 0/36 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#no stack-unit 0 port 37 portmode quad
Disabling quad mode on stack-unit 0 port 37 will make interface configs of Te 0/37 Te 0/38
Te 0/39 Te 0/40 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#no stack-unit 0 port 49 portmode quad
Disabling quad mode on stack-unit 0 port 49 will make interface configs of Te 0/49 Te 0/50
Te 0/51 Te 0/52 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#no stack-unit 0 port 53 portmode quad
Disabling quad mode on stack-unit 0 port 53 will make interface configs of Te 0/53 Te 0/54
Te 0/55 Te 0/56 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#
2 Save the conguration.
Dell#write memory
!
01:05:48: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in
flash by default
Dell#reload
Proceed with reload [confirm yes/no]: yes
142
Link Aggregation