Users Guide
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
EXEC Privilege mode
clear counters [interface]
When you enter this command, you must conrm that you want Dell Networking OS to clear the interface counters for the interface (refer
to the below clearing interface example).
Clearing an Interface:
Dell#clear counters tengig 0/0
Clear counters on TenGigabitEthernet 0/0 [confirm]
Dell#
Enabling the Management Address TLV on All
Interfaces of an Aggregator
The management address TLV, which is an optional TLV of type 8, denotes the network address of the management interface, and is
supported by the Dell Networking OS. It is advertised on all the interfaces on an I/O Aggregator in the Link Layer Discovery Protocol
(LLDP) data units. You can use the
show running-configuration command to verify that this TLV is advertised on all the
congured interfaces and the show lldp neighbors detail command to view the value of this TLV.
Enhanced Validation of Interface Ranges
You can avoid specifying spaces between the range of interfaces, separated by commas, that you congure by using the interface
range
command. For example, if you enter a list of interface ranges, such as interface range fo 2/0-1,te 10/0,gi 3/0,fa
0/0, this conguration is considered valid. The comma-separated list is not required to be separated by spaces in between the ranges. You
can associate multicast MAC or hardware addresses to an interface range and VLANs by using the
mac-address-table static
multicast-mac-address vlan vlan-id output-range interface command.
Enhanced Control of Remote Fault Indication
Processing
By default, the M I/O Aggregator module processes RFI errors transmitted by remote peers and brings down the interface when an RFI
error is detected.
You must enter the interface conguration mode before conguring Remote Fault Indication (RFI).
You can use the following CLI commands to enable or disable processing of received RFI events:
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
The default is "remote-fault-signaling rx on".
Interfaces
119