Users Guide

Table 11. Auto-Negotiation, Speed, and Duplex Settings on Dierent Optics
Command Mode 10GbaseT
module
10G SFP+
optics
1G SFP optics Copper SFP -
1000baseT
Comments
speed 100 interface-cong
mode
Supported Not
supported(Err
or message is
thrown) (%
Error: Speed
100 not
supported on
this interface,
cong ignored
Te 0/49)
Not supported(Error
message is thrown) (%
Error: Speed 100 not
supported on this
interface, cong ignored
Te 0/49)
% Error: Speed
100 not
supported on
this interface,
speed auto interface-cong
mode
Supported Not supported Not supported Not supported Error messages
not thrown
wherever it says
not supported
speed 1000 interface-cong
mode
Supported Supported Supported Supported
speed 10000 interface-cong
mode
Supported Supported Not Supported Not supported Error messages
not thrown
wherever it says
not supported
negotiation auto interface-cong
mode
Supported Not
supported(Sh
ould some
error message
be thrown?)
Not supported Not supported Error messages
not thrown
wherever it says
not supported
duplex half interface-cong
mode
Supported CLI not
available
CLI not available Invalid Input
error- CLI not
available
duplex full interface-cong
mode
Supported CLI not
available
CLI not available Invalid Input
error-CLI not
available
Setting Auto-Negotiation Options:
Dell(conf)# int tengig 0/1
Dell(conf-if-te-0/1)#neg auto
Dell(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
Dell(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-autoneg)#
Interfaces
117