Users Guide
can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-address-table static
multicast-mac-address vlan vlan-id output-range interface command.
Bulk Conguration Examples
The following are examples of using the interface range command for bulk conguration:
• Create a Single-Range
• Create a Multiple-Range
• Exclude a Smaller Port Range
• Overlap Port Ranges
• Commas
Create a Single-Range
Creating a Single-Range Bulk Conguration
Dell(conf)# interface range tengigabitethernet 0/1 - 23
Dell(conf-if-range-te-0/1-23)# no shutdown
Dell(conf-if-range-te-0/1-23)#
Create a Multiple-Range
Creating a Multiple-Range Prompt
Dell(conf)#interface range tengigabitethernet 0/5 - 10 , tengigabitethernet 0/1 , vlan 1
Dell(conf-if-range-te-0/5-10,te-0/1,vl-1)#
Exclude a Smaller Port Range
If the interface range has multiple port ranges, the smaller port range is excluded from the prompt.
Interface Range Prompt Excluding a Smaller Port Range
Dell(conf)#interface range tengigabitethernet 2/0 - 23 , tengigab 2/1 - 10
Dell(conf-if-range-te-2/0-23)#
Overlap Port Ranges
If overlapping port ranges are specied, the port range is extended to the smallest start port number and largest end port number.
Interface Range Prompt Including Overlapping Port Ranges
Dell(conf)#inte ra tengig 2/1 - 11 , tengig 2/1 - 23
Dell(conf-if-range-te-2/1-23)#
Commas
The example below shows how to use commas to add dierent interface types to the range, enabling all Ten Gigabit Ethernet interfaces in
the range 0/1 to 0/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2.
Multiple-Range Bulk Conguration Gigabit Ethernet and Ten-Gigabit Ethernet
Dell(conf-if)# interface range tengigabitethernet 0/1 - 23, tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-0/1-23)# no shutdown
Dell(conf-if-range-te-0/1-23)#
Interfaces
109