Administrator Guide

Input Statistics:
...
User
Information
Both sides of the link must have auto-negotiation enabled or disabled for the link
to come up.
The following details the possible speed and auto-negotiation combinations for a
line between two 10/100/1000 Base-T Ethernet interfaces.
Port 0
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled* speed 1000 or auto
Port 1
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
• Up at 1000 Mb/s
• Up at 100 Mb/s
• Up at 100 Mb/s
• Down
• Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
Related
Commands
speed (for 1000/10000 interfaces) — sets the link speed to 1000, 10000, or auto-
negotiate the speed.
source (port monitoring for 40-Gigabit Ethernet)
Configure a port monitor source and destination. Starting with Dell Networking OS Release 9.3(0.0), you
can also configure a 40-Gigabit Ethernet interface as the destination interface or port to which the
monitored traffic is sent .
Syntax
source interface destination interface direction {rx | tx |
both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
156
Interfaces