Administrator Guide

Related
commands
group — Configures a range of command (bulk configuration)
interface range macro (define) — Defines a macro for an interface range (bulk
configuration).
interface vlan
Configure the default VLAN to enable Static or DCHP IP configuration
Syntax
interface vlandef-vlan-id
Parameters
def-vlan-id Enter 1 for the default VLAN.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
For more information about VLANs and the commands to configure them, refer to
Virtual LAN (VLAN) Commands.
Example
Dell(conf)#int vlan 1
Dell(conf-if-vl-1)#
Related
commands
show vlan — Displays the current VLAN configuration on the switch.
vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4
autoneg
command to set the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Command
Modes
CONFIGURATION
150
Interfaces