Administrator Guide

dcbx version
Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the no dcbx version {auto | cee | cin
| ieee-v2.5} command.
Parameters
auto | cee | cin
| ieee-v2.5
Enter the DCBX version type used on the interface, where:
• auto: configures the port to operate using the DCBX
version received from a peer.
• cee: configures the port to use CEE (Intel 1.01).
• cin: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
• ieee-v2.5: configures the port to use IEEE 802.1az
(Draft 2.5).
Defaults Auto
Command
Modes
PROTOCOL LLDP
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail
command.
qos-policy-output ets
To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.
Syntax
qos-policy-output policy-name ets
To remove the QoS output policy, use the no qos-policy-output ets
command.
Parameters
policy-name Enter the policy name. The maximum is 32 characters.
Command
Modes
CONFIGURATION
104
Data Center Bridging (DCB)