Users Guide

u-Boot

All commands in this chapter are in u-Boot mode. These commands are supported on the Dell Networking Aggregator only.

To access this mode, hit Esc key when the following line appears on the console during a system boot: Hit Esc key to interrupt

autoboot:

You enter u-Boot immediately, as indicated by the BOOT_USER# prompt.

NOTE: Only the most frequently used commands available in uBoot mode are described in this chapter.

In uBoot mode, you cannot use the Tab key for command completion.

Topics:

• boot change

• boot selection

• boot show net cong retries

• boot write net cong retries

• boot zero

• default gateway

• enable

• help

• ignore enable password

• ignore startup-cong

• interface management ethernet ip address

• no default gateway

• no interface management ethernet ip address

• reload

• show boot blc

• show boot selection

• show bootash

• show bootvar

• show default gateway

• show interface management ethernet

• show interface management port cong

• syntax help

boot change

Change the operating system boot parameters.

Syntax

boot change [primary | secondary | default]

Command Modes uBoot

Supported Modes All Modes

u-Boot 81