Users Guide

Storm Control
The Dell Networking operating software storm control feature allows you to limit or suppress trac during a trac storm.
Important Points to Remember
• Interface commands can only be applied on physical interfaces (virtual local area networks [VLANs] and link aggregation group [LAG]
interfaces are not supported).
• An INTERFACE-level command only supports storm control conguration on ingress.
• An INTERFACE-level command overrides any CONFIGURATION-level ingress command for that physical interface, if both are
congured.
• You can apply the CONFIGURATION-level storm control commands at ingress or egress and are supported on all physical interfaces.
• When storm control is applied on an interface, the percentage of storm control applied is calculated based on the advertised rate of the
line card. It is not based on the speed setting for the line card.
• Do not apply per-VLAN quality of service (QoS) on an interface that has storm control enabled (either on an interface or globally).
• When you enable broadcast storm control on an interface or globally on ingress, and DSCP marking for a DSCP value 1 is congured for
the data trac, the trac goes to queue 1 instead of queue 0.
• Similarly, if you enable unicast storm control on an interface or globally on ingress, and DSCP marking for a DSCP value 2 is congured
for the data trac, the trac goes to queue 2 instead of queue 0.
NOTE
: Bi-directional trac (unknown unicast and broadcast) along with egress storm control causes the congured trac rates
split between the involved ports. The percentage of trac that each port receives after the split is not predictable. These ports
can be in the same/dierent port pipes or the same/dierent line cards.
NOTE: The policy discard drop counters are common across storm-control drops, ACL drops and QoS drops. Therefore, if your
conguration includes ACL and QoS, those drops are also computed and displayed in the policy discard drops counter eld along
with storm-control drops. The packets dropped by the storm control feature can be monitored by viewing the value of the Policy
Discard Drops eld of the output of the show hardware stack-unit 0 drops command.
Topics:
• io-aggregator broadcast storm-control
• show io-aggregator broadcast storm-control status
• storm-control PFC/LLFC
• storm-control multicast (Interface)
• storm-control broadcast (Interface)
• show storm-control unknown-unicast
• storm-control unknown-unicast (Interface)
io-aggregator broadcast storm-control
Rate-limit the trac storm to 1 Gbps.
Syntax
io-aggregator broadcast storm-control
To disable storm control, use the no io-aggregator broadcast storm-control command.
27
Storm Control 359