Users Guide

To remove a user from the SNMP group, use the no snmp-server user name {group_name [access
access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-
name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that connects to
the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The following
groups are created for mapping to read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
access access-list-
name
(Optional) Enter the standard IPv4 access list name (a string up to 16 characters long).
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then the IPv6 access list name (a string up to 16
characters long).
access-list-name
ipv6 access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0)
Introduced on the M I/O Aggregator.
Usage Information
NOTE: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP. TCP and ICMP rules are not valid
for SNMP. In IPv6 ACLs port rules are not valid for SNMP.
No default values exist for authentication or privacy algorithms and no default password exists. If you forget a
password, you cannot recover it; the user must be recongured. You can specify either a plain-text password or an
encrypted cypher-text password. In either case, the password is stored in the conguration in an encrypted form
and displayed as encrypted in the show running-config command.
If you have an encrypted password, you can specify the encrypted string instead of the plain-text password. The
following command is an Example of how to specify the command with an encrypted string.
NOTE: The number of congurable users is limited to
16.
Example
Dell# snmp-server user privuser v3group v3 encrypted auth md5
9fc53d9d908118b2804fe80e3ba8763d priv des56 d0452401a8c3ce42804fe80e3ba8763d
Usage Information The following command is an example of how to enter a plain-text password as the string authpasswd for user
authuser of group v3group.
348 Simple Network Management Protocol (SNMP) and Syslog