Users Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To specify the name of the output QoS policy, use this command. After the output policy is specied, rate-limit,
bandwidth-percentage, and WRED can be dened. This command enables Qos-Policy-Output Conguration mode
— (conf-qos-policy-out).
Related Commands
bandwidth-percentage — assigns weight to the class/queue percentage.
rate-shape
Shape the trac output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Make the
following value a multiple of 64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to 10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-OUT
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you apply rate-shape in QoS policy both on the Queue Level and in Aggregate mode, the queue-based
shaping occurs rst then aggregate rate shaping.
service-class bandwidth-percentage
Specify a minimum bandwidth for queues.
Syntax
service-class bandwidth-percentage queue0 number queue1 number queue2 number
queue3 number
Quality of Service (QoS) 301