Users Guide

show running-cong monitor session
Displays the running conguration of all monitor sessions or a specic session.
Syntax
show running-config monitor session {session-ID}
To display the running conguration for all monitor sessions, use the show running-config monitor
session command.
Parameters
session-ID (OPTIONAL) Enter a session identication number. The range is from 0 to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The monitoring command is saved in the running conguration at the Monitor Session mode level and can be
restored after a chassis reload.
Example
Dell# show running-config monitor session
!
monitor session 1
source TenGigabitEthernet 0/1 destination TenGigabitEthernet 0/2 direction rx
Related Commands
monitor session— creates a session for monitoring.
show monitor session— displays a monitor session.
source (port monitoring)
Congure a port monitor source.
Syntax
source interface destination interface direction {rx | tx | both}
To disable a monitor source, use the no source interface destination interface direction
{rx | tx | both} command.
Parameters
interface Enter the one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
destination Enter the keyword destination to indicate the interface destination.
direction {rx | tx |
both}
Enter the keyword direction followed by one of the packet directional indicators.
• rx: to monitor receiving packets only.
Port Monitoring 295