Users Guide

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command applies to dynamic port-channel interfaces only. When applied on a static port-channel, this
command has no eect.
lacp port-priority
To inuence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports from
aggregating, congure the port priority.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
priority-value Enter the port-priority value. The higher the value number, the lower the priority. The
range is from 1 to 65535. The default is 32768.
Defaults 32768
Command Modes INTERFACE
Supported Modes
Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
port-channel mode
Congure the LACP port channel mode.
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active state.
NOTE: LACP modes are dened in Usage
Information .
passive Enter the keyword passive to set the mode to the passive state.
NOTE: LACP modes are dened in Usage
Information .
o Enter the keyword off to set the mode to the o state.
254 Link Aggregation Control Protocol (LACP)